PT Sanko Gosei Technology Indonesia
Sanko Gosei is a Japanese company that supplies high quality components and systems in various market sectors by viewing the portfolio gradually and develop in the customer and to satisfy customers’ expectations as a reflection of good performance. Sanko Gosei Technology in Indonesia is only focusing on producing in the field of injection molding for automotive exterior and interior products made of plastic. Customer from PT. Sanko Gosei Indonesia itself is diverse as Toyota, Honda, Mitsubishi, Daihatsu and Denso.
On this occasion, Industrial Engineering Student Association (HIMTRI) of Binus University held industry visit event to PT. Sanko Gosei Technology Indonesia which located in Karawang, Bekasi. The industry visit was held on Wednesday, May 10, 2017 with participants approximately 50 people with 1 lecturer. Participants gather at BINUS admission Anggrek Campus to go together to PT. Sanko Gosei. The trip is quite far and takes much time because the road conditions on the highway when it is very jammed. We arrived at PT. Sanko Gosei Technology Indonesia approximately at 11.30. When participants get off the bus the participants are warmly welcomed by PT. Sanko Gosei employees. Participants directed to enter a room, where the speakers and corporate executives has gathered.
After all of the participants entered the room, the opening ceremony began with a welcome speech by the president director of PT. Sanko Gosei Technology Indonesia and continued greeting from Binus University by supervisor. After the greeting, company explained a little about the company and continued with a tour / tour into the factory company. There, participants are given direction and knowledge how to manufacture products produced by the company. Then after finished the tour, the participants are given some time to ask if anyone wants to ask about PT. Sanko Gosei. After the Q & A session is complete, Binus University representative give a word of thanks to PT. Sanko Gosei Technology Indonesia by lecturers and chief executor of industry visit event by giving a plaque as an award. Then the photo session was held outside the company building, after the photo session was completed the participants returned to Binus Anggrek Campus at 13:30.